edge nemesis image to flash ?

[kitkat60]

trying to put edge nenesis 4.4 into technomate 9100s but it will not load with tech control center can anyone help

[bobbydee]

Try and use technomate 7.1 control center.If this is not possible I can send you one to put on a sd card and install it that way.

[kitkat60]

tryed 7.2 control center m8 do i have to do a factory reset first

[echelon]

you should always do a factory reset before and after before trying flash images

and sometimes you wont completely clear the flash out , so may be worth rtrying a uboot image first ( uboot or noboot , can never remember which one it is ) , and again the double factory resets before and after each flash

this is one reason I dont like flashing the flash with images , and so I use ds boot image in the flash and all other images are on an sd card

edg v4.4 works well with this method and you dont risk messing up the flash

[kitkat60]

then i need a sd card could you recomend on please

[echelon]

almost any 1 gig or 2 gig sd card will do the job , depends what you can find and where , but they are only a few pounds or so to buy

if you have any old 250mb or 500mb ones then use one of those

you can use other memory cards , but the sd card is common , robust and very cheap

try svp or play or amazon or 7dayshop , beware of fakes on places like auction sites however

the good thing about using sd cards is that the flash is rarely updated , it stays the same and your card takes the strain , and you can try dreambox images as well as technomate ones ( nabilo and gemini work on the tm , but use the tm ported versions not the dreambox ones, which means only look in this tm9100 forum for the images , or any other tm9100 forum, not dreambox )

[kitkat60]

great help thanks m8