Technomate 5200d troubles

[cranlor]

Re-Technomate 5200D SUPER
Lost Digi film & other $ indicated channels......went onto S*TP***s and got latest patch and Softcam key from C**PA*s & installed via usb with Digi au left in off mode and all others in on.
All running fine until Saturday when THOR Quality has dropped to 20% and picture breaking up cannot get any Thor channels at all.
Am I missing something .
How do I check receiver is set to N53.6 W3.0...Also do I need to reset THOR

[satpaul]

Put latest patch in Turn Digi AU to on leave on Digi Film1 and it will update in less than 2 mins
Dish has moved change W to 2.0 and see if signal increases

[cranlor]

Thanks set dish at 4.0 w and all ok now

[satpaul]

Its been quite windy lately specially where you are

[cranlor]

thanks Paul was ok but now lost all channels including astra(freeview)
Thor set at 000 w was running all $ channels ok ,

[nosmo king]

If 0.8 west
Is now 4.0 west

Then all sats moved 3.2 degrees west

28.2 now 25
19.2 now 16
16 now 12.8

You got serious problem there id get that looked at before it gets worse

[cranlor]

Take it then all easts decrease by same amount , thanks

[satpaul]

Give me a call

[williamtell]

can`t you just tweek to best signals ie astra1/ 2/ hotbird thor etc and save sats again? seems daft to get installer call out ie £££££

[cranlor]

Strange but all ok now ...tweaked each one using pos , Turned off receiver and hey presto all as good as new .
THANKS GUYS