Technomate 1500Ci "No or Bad Signal" with Diablo CAM

[Youngbootsy]

Hi Guys,

Wondering if you can help me out.
I quite often get a problem with "No or Bad Signal" on my Technomate 1500Ci when trying to clear channels on Th0r 1w (N@gra2 and C0n@x). It normally happens after I look for a channel on another satellite ie 16e or 19.2e then go back to th0r. The only way I can get it back is do a blind search on Th0r 1w again. After a little while it will start clearing the channels again.
Its starting to get my goat now!
Is it a common problem with my box or is there a quick fix?
Also, when i do a blind search it tells my that the is not enough memory.

Cheers for any advice you can give me.

Youngbootsy

[Aldo]

Hi M8

When you get "No or Bad Signal ", it usually means that your receiver is not correctly on the Sat that you are trying to receive the channels from, doing a Blind Scan will always top up your memory very quickly, you would be well advised to just use the Auto Scan, and just scan for TV channels, unless you want 100's of Radio channels that you may never use. You can get more info to try and help you with your current problem in post 7 here:

https://www.satpimps.co.uk/showthread.php?t=58273

[maud]

Get that message moving from about 16 deg east to thor because dish is still moving left a minute and dish is in position then it clears ok.
Also when you get it working save a copy of your channel list on your computer so you can reload it at any time.

[Aldo]

@Youngbootsy

You can get some more info ref blind scan, adding & removing transponder, channels etc:

https://www.satpimps.co.uk/showthread.php?t=100533