symbol rate

[icedemon]

There are some channels that didn't come up with the scan left to do it's own thing. However when I try to manually add the channel it wont let me adjust the symbol rate to the one I need to have it selected as.

I wish to select
28.2
tp freq 12012
symbolrate 29500
polarization vertical

After using azboxedit I manually put in the data, but when I search I get 0 results and have 0% Quality orange bar.

Is it just that the transponder signal is too weak? Or is this an azbox fault?

edit: sometimes quality goes to 72% but scan still shows 0 channels.

[satwyn]

mpeg/2 HD not mpeg/4 HD is this still possible with the az I will try and see what happens

[icedemon]

I don't understand, I'm sure they must be MPEG-4 HD.

[Giga]

could be these settings for that transponder mentioned:
DVB-S2 (QPSK) (not DVB-S2 (8PSK)
FEC 3/4 (auto does not work on dvb-s2?)
Pilot on/off (if settings match for above parameters try other setting)

[happyhammer]

There are some channels that didn't come up with the scan left to do it's own thing. However when I try to manually add the channel it wont let me adjust the symbol rate to the one I need to have it selected as.

I wish to select
28.2
tp freq 12012
symbolrate 29500
polarization vertical

After using azboxedit I manually put in the data, but when I search I get 0 results and have 0% Quality orange bar.

Is it just that the transponder signal is too weak? Or is this an azbox fault?

edit: sometimes quality goes to 72% but scan still shows 0 channels.

make sure you have it set for DVB-S2 (QPSK) and if that dont work, set pilot = 1

[icedemon]

could be these settings for that transponder mentioned:
DVB-S2 (QPSK) (not DVB-S2 (8PSK)
FEC 3/4 (auto does not work on dvb-s2?)
Pilot on/off (if settings match for above parameters try other setting)



make sure you have it set for DVB-S2 (QPSK) and if that dont work, set pilot = 1


Quality goes to 70% if I adjust parameters to S2 QPSK, FEC 3/4 and pilot off. Scan gives 0 channels. Pilot on, 0% quality, still 0 channels.

[happyhammer]

i take it its 28.2 E yer talking about.

try this.

using remote. remove Transponder 12012 from box

then add tp 12012 with the correct settings.

[icedemon]

i take it its 28.2 E yer talking about.

try this.

using remote. remove Transponder 12012 from box

then add tp 12012 with the correct settings.

That worked, thanks buddy.