No signal since I have upgraded to 0.9.3661

[ripper77]

Since I have upgraded to version 0.9.3661 it happened 3 times already to loose the signal on all satellites.
Even I reboot the box I still don't have signal on any TP or Satellites. The only workaround is to unplug the power cable and then it's working again.

This has not happened before with the old 0.9.2371 that I was using it for more than 3 months.

Does anyone know why this happens?

[xanadu]

Probably you need to rescan all satellites and check your settings.

[ripper77]

I can't scan because there is no signal on the satellite .


I have tried to restore to factory settings but this has not helped.

[hanswurscht]

then look for your Diseqsettings and set it right

[ripper77]

As I said if I unplung the power cable everything is back to normal when the box restarts.

Now I have upgraded to the latest version. Lets see how it goes with this one.

[ripper77]

I have the same problem with 0.9.3686.

I will go back to 0.9.2371 and see how it goes. I really hope that this is a software issue and not a hardware problem.

[enrico001u]

Silly question but have set up your satellites again for your config IE: diseqc settings or motor settings?

[ripper77]

When I put a new firmware first I format application area.

Obviously I have to re-configure the DISEq settings each time. This is not the problem.

I don't have a reproducer but I suspects that this happens when I access TPs with low signal.