how do you know if its 4.2.2 or encrypted after blindscan

[iwols]

just done a blindscan on 10e,but how do you know if its a 4.2.2 feed or the signal is encrpted,its just that it saves time putting the freq into my azbox if its an encrypted channel instead of a 4.2.2 signal thanks

[stamfordblue]

If it's encrypted it would show as Biss under encryption.
Not familiar with Technomate but may show under Info.

[pmb]

On my 6800HD non super it will say scrambled channel if it is encrypted. With 4:2:2 it says no audio/video. The screen stays black unlike my earlier 5500CI that shows lots of coloured squares with audio clearing. I didn't think the audio cleared on the 6800 but it did this morning on 7E for the shuttle launch that I watched (in 4:2:2) on the skystar2 card in the pc until they put the feed up on 10E (and s*y) in 4:2:0

[Giga]

if you press info on RCU and it shows $= encrypted pay TV
press a second time and it will show the used coding: powervu, seca, nds, ... and sometimes leave it blank or perhaps unknown (not 99% on this).