j@mes
04-02-2010, 12:44 PM
Hi guys
Previous to my Technomate had Humax 5300. The LNB Loopthrough was connected to my PC
Sat Card (Skystar 1).
When Humax on Standby, Sat card recieved V and H channels.
When Humax on, recieved polarity of channel being recieved on Humax
In niether of these modes was any noticable voltage on Loopthrough output,
OK this is I would have thought how it should be.
On Technomate however having problems with loopthrough. On investigation I find that when Technomate is on thier is the full lnb voltage on the loopthrough.
Is this correct?
The reason I ask is my Skystar Card has gone faulty since Technomate Super HD Combo pvr installed. This was connected to the loopthrough.
On further investigation I find the Skystar is no longer giving a LNB Voltage out.
Checked Settings and LNB voltage is not turned off.
Previous to my Technomate had Humax 5300. The LNB Loopthrough was connected to my PC
Sat Card (Skystar 1).
When Humax on Standby, Sat card recieved V and H channels.
When Humax on, recieved polarity of channel being recieved on Humax
In niether of these modes was any noticable voltage on Loopthrough output,
OK this is I would have thought how it should be.
On Technomate however having problems with loopthrough. On investigation I find that when Technomate is on thier is the full lnb voltage on the loopthrough.
Is this correct?
The reason I ask is my Skystar Card has gone faulty since Technomate Super HD Combo pvr installed. This was connected to the loopthrough.
On further investigation I find the Skystar is no longer giving a LNB Voltage out.
Checked Settings and LNB voltage is not turned off.