v box

[andy]

i am using a v -box 11 with my azbox elite to move the dish i havnt had any problems with it untill the last couple of days i cant get it to move to 4 east 10 east 13 east or 1 west when i move to those sats the azbox responds as though the dish has been moved but the v box doesnt respond
when i go to antenna setup the
lnb freq has been changed to 0mh from universal
LNB power to off from on
positioner setup to off from DiSEqC1.2
network search to NIT from normal
when i change them back to where they were before it still doesnt work

does anyone know how to sort this out :confused:

[iwols]

have you done a blindscan recently

[andy]

no never do blind scans

[iwols]

what about channel editing

[andy]

no

i updated the firmware to the latest one and downloaded some plugins openXcas and livefeeds then i read i had to go to west 1 to see if it would open channels there i done the sat scan on west 1 (is that what you mean by blind scan)


as you can see im new to all this

[SatSearcher]

I have the same set-up, but just use the v-box as a manual positioner, i don't trust the azbox to control it!

[the illuminati]

you have to reset the pos in azbox and do the pos all over again

[andy]

so i cant do a sat scan as it will mess up the v box every time ??

[tx0]

reset the limits on vbox. then set it back. don't do blindcan at all.