Humax IRCI-5400 help please

[chaves]

I received humax 5400 and it was with motorized setting.Please can anyone tell me what to do to
factory reset and what do I have to use to load all the latest firmware and others things.I have been reading on the forum about humax and downloaded:Kiiab 1.3 , Pmct_2010-13-19 toh34ht11.4b,
channel listing monoblock, humax5400 dsr csstudio 1.2, setlockedithumax v.3.
I `ve got monoblock astra 19-hotbird 13 and I need new channel listing monoblock setting.
How do I use all of that? or if you can tell me step by step how to do it.
Thank you so much for all help

[Marco]

This could help chaves

https://www.satpimps.co.uk/showpost.php?p=394665&postcount=3

[chaves]

I loaded original HIC10500-00 with WDN4OAK+ ,after TOH3.4HOT 11.4 and then Tried to load channel settings with HNFsmart,did not work , shows ( error-id) and tried to load key bin with Kiab 1.3 did not work.Before I load original software,I could have on
main menu option to make config card-emu-cs,and to nagra I could change to on or auto,now I can`t see that.Is there any code to activate the emu to make me see again options like these.Thanks Marco for help me.

[Marco]

Hi chaves when you load hnf smart i take it you have
went into the config and click on IRCI 5400 and save changes
also when i load keybins i have to
disconect cable From back of hummy
turn hummy off and on.
and put cable in hummy you could try this..

go into ToH config menu and change settings

card+emu
Nagra2 AU off

[Marco]

Glad you are sorted chaves.

:respect-056:

[chaves]

Marco,
Thank you so much for your help