View Full Version : TM-6900 Super rebooting ?
sat_rrstm
30-08-2010, 05:47 PM
My TM-6900 Super keeps rebooting when I plug it in the mains after an overnight unplug,and stays switched-ON after the 3rd rebooting.
That started happening from the first use of Phantompatch-729p (18-08-2010).
Is it the same for anyone else,please?
If so,I hope Phantom can fix it on his next release.
Thank you Mr Phantom,wherever you are. :respect-055:
check your channel list: remove unused satellites, if you don't use radio clear radio channels. Have you done some blind scans: remove double transponders See if this helps
you can do this on your computer with this channel editor:
https://www.satpimps.co.uk/showthread.php?t=110802
sat_rrstm
30-08-2010, 06:00 PM
I have only 8 sat's installed,around 1800 TV & 30 radio ch's only and I have already deleted empty transponders,so any other clue?
Thanks for the quick responding,mate.
heat problem? using cam(s), check if table ventilator can cool the box down?
sat_rrstm
30-08-2010, 06:11 PM
No heat problem,as I said this happens after an overnight unplug,as well,no CAM in use either.
Do you use the same receiver & patch with no such a problem?
Have 2 of these. One running daily from 6.00 to 23:00. Disconnect power after putting in standby with a switch on power strip. Disconnecting by pulling plug (and not using power switch) could cause arcing? Both are connected on home network to. Are you using C S over ethernet?
Try this save your current channel list, put in on usb stick: if motorized note your settings for motor setup on paper, just in case.
If multi feed and diseqc switches note these settings on paper.
Download patch again from this forum, unpack it with 7zip:
www.7-zip.org
just in case, something could be corrupted by unpacking
do the same for add-on
put these on stick
load patch
do a factory reset
load add-on
load your channel list: do it twice using 1st option and the 2nd option
load keys
hope this solves your problem.
sat_rrstm
30-08-2010, 08:57 PM
Thank you very much @Giga,the factory reset before and after downloading the patch did the trick.No add-on used.
Cheers!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.