No Signal

[hakxxx]

Hi
Does anyone losing signal while watching a channel? I am watching a movie and 10-15 mins later Signal Lost, no channel available till I reboot from the back of the machine. It is killing me.
Thanks
help appreciated

[hakxxx]

I just applied last patch by the way. It didnt make any difference. Do you think i need to reimage the azbox elite?
thanks

[dizzy]

make your own channel list from azbox

[mkris]

... check in setting parameter "Hardware acceleration" OFF.

[hakxxx]

so, hardware acceleration should be on or off?
i shouldnt use tv lists that i downloaded?
thanks guys

[mkris]

Hi
Does anyone losing signal while watching a channel? I am watching a movie and 10-15 mins later Signal Lost, no channel available till I reboot from the back of the machine. It is killing me.
Thanks
help appreciated

this problem i had on my one box and when i OFF hardware acceleration all is OK.

[scopus]

Hi
Does anyone losing signal while watching a channel? I am watching a movie and 10-15 mins later Signal Lost, no channel available till I reboot from the back of the machine. It is killing me.
Thanks
help appreciated

I too had this problem...a format of the application area sorted mine out:hurray:

[grassbox]

Could be a problem with the lnb. Components within the lnb may be breaking down electrically and changing state when powered off then on.

[xanadu]

My guess is the HW Acceleration causing overheating. Turn it off.

In the Premium Plus there is less problems with HWA, as there is a fan.

[buyukbang]

This was happened me before, after 3-4 mounths of azbox usage. I changed the diseq and the problem is solved.

After 6 mounts, today it reoccured :( Now I'm suspecting that azbox causes the diseq to die in some way (may be overvoltage).

Now I need to buy another diseq :(

[hfmls]

after i tested enigma2 and come back to KGD firmware i get a lot of no signal messages too...strange...gotta test more

[daleelis]

I think it's not related to diseqc. Same problem here using DVB-C ("no signal" message).
To temporarily fix it I change to a DVB-S channel and go back to the DVB-C channel. Doing this the problem goes away and everything works fine again.

[morana]

I also noticed that proximity to other electrical devices causes me to get a no signal message. Move it and it works fine.

[rover]

hi guys, i think its azbox software, i have a technomate linked to the same circuit, when i had this problem i switch over to the technomate it was fine,i found when i leave it on the station with no signal just do a reboot and it comes back regards

[ripper77]

I had the same problem.

I had to change the cable that connects the tuner to the motherboard and the power supply from inside.

After these have been replaced no more NO SIGNAL issues.

Cheers.