CommandFail

[beamobhoy]

Just switched to RC4 and have got CommandFail on my VFD and the azbox is dead - won't respond to reboots from either remote or on the STB - is it dead? anyone else had this? I have switched the box off at the back and unplugged it as well but on turning back on, nothing!

[satstarter]

Try to shut it down on the back
put a usb in the front with rc4
try to power it on again in the back
now he should go in rescue mode and give you a ip nr
if you have dhcp enabled in your router.

if it does then turn azup on on your pc and try to flash your box again

good luck

[beamobhoy]

thanks - did all that. Got it working again but it took a deep sleep to sort it (20 mins was go good so tried an hour and it rebooted). Strange that the box didn't react at all until after this deep sleep - perhaps it's been working too hard testing e2!!!!