ET9000 and cccam

[silenthilldan]

Hello,

I have followed all the steps of configuration for the ET9000 but still cannot get it to work with my cccam. I'm using OpenPLI 2.0 + cccam 2.2.1

When I look at cccam-info, all servers are Red although the box is correctly networked and cccam correctly configured.

When I plug back my DM7020 with same cccam, all works fine....
Any hints please?

[kooleracer]

go to setup CI / softcam and enable or start cccam manualy and also enable automatic startup.

[silenthilldan]

Thanks kooleracer but...

I have done this already, doesn't change anything...

[H4XoR]

Have you uploaded the CCcam.cfg file to the correct folder?

It should go in the /etc folder.

Restart CCcam after uploading the cfg file.

[silenthilldan]

Yes, uploaded in the /etc folder with DCC and also tried with ET9000CC tool....
I can open/edit directly with FTP.

Restarted the cccam but no luck....

[H4XoR]

Have you got the DM7020 connected to the router at the same time as the ET9000?

If so disconnect the DM7020 from the router.

[silenthilldan]

I think it was connected....
I will try without it and will let you know....

[silenthilldan]

Thanks a lot H4xor !!
Disconnecting the DM7020 solved the problem :-)

[echelon]

Thanks a lot H4xor !!
Disconnecting the DM7020 solved the problem :-)

sounds like you tried to use the same details twice , which is a no-no

its use the line in one box , or the other box , but not both at the same time !

same applies to local ip`s too , use different ones for different boxes