blakmumba
14-12-2012, 06:57 AM
Has any1 managed to get mgcamd working stable with the latest firmware for the s4000?
Been trolling the net for past few hours configuring mg_cfg file but to no avail.
My problem(s) as follows...
>If time shift is active and used (paused, rewind etc), the screen goes blank (every channel) and eventually hard locks the ice, need to switch off from mains and back on to recover.
>Whilst recording and using the standby feature this also locks the ice, so again having to resort to mains again.
Any advice would be much appreciated :)
Been trolling the net for past few hours configuring mg_cfg file but to no avail.
My problem(s) as follows...
>If time shift is active and used (paused, rewind etc), the screen goes blank (every channel) and eventually hard locks the ice, need to switch off from mains and back on to recover.
>Whilst recording and using the standby feature this also locks the ice, so again having to resort to mains again.
Any advice would be much appreciated :)