PDA

View Full Version : New problem with the Elite


Dig Deep
13-08-2013, 10:02 AM
Had some problem with ccc, the box did not work so I decided to upgrade (RSI)

After the upgrade was done it stopped at VFD ready and nothing more.

However - it was working fine using DCC, got in all all was showing.

Tested the simple way to go to safety using AZup and it sarted to reboot into safe mode but never did a good reboot, stopped at VFD again.

Dunno why this happen and how to get it back into real life :lurk5: any ideas are welcomed !
zeini
13-08-2013, 12:02 PM
Disconnect all HDD and USB-devices and try it again.

If this doe also not work, perhaps your imagefile is defect.
Dig Deep
14-08-2013, 08:08 AM
Yes I Think it is defect for sure. Problem is How to re-install or even install something else.
Canīt find a way ?
Carp95
14-08-2013, 09:24 AM
Reboot - press volume up

Be shure receiver is connected through LAN cable not wirelles and DHCP server is enabled on router/modem

Box wil start in resque mode, now install requered image with Azup 2.2.7 ( windows 7/8 give rights to Azup in windows firewall )
Dig Deep
16-08-2013, 07:06 AM
It wonīt start in resque mode and if I start Azup it will (of course) try to restart the box in resque but after the reboot
it goes back into just waiting for the image to load. It is a sad loop.
zeini
16-08-2013, 08:05 AM
Press Vol+ button during start of azbox. Than you see IP-adress in VFD you can stop pressing Vol+ and flash your box. And very important - flash only with Azup 2.2.7.