echelon
28-08-2013, 04:41 PM
Spiderbox None Usals Vbox Setup. (on Spiderbox 7000/9000/9900)
1. If you have used your Vbox with any other receiver reset it before commencing with this guide.
2. On your remote Menu-Installation-Motor Setup. Enter 0000 at the prompt.
3. Motor Type = Motor
4. Satellite Tab start at 42E so we can progress across the arc numerically 39E then 36E etc.
5. To search for the satellite use the Drive step option as this uses small movements, inching it till you gain signal lock. Try other transponders to check the lock is on the correct orbital position.
6. To Store the position scroll to the command tab and press OK. This will store the orbital slot to the first available position number on the vbox, hence why I suggested you reset the Vbox at the start of this Guide.
7. Now repeat the above across the arc until you have stored all the orbital positions you require.
That’s it your done.
by ferret (thank you)
1. If you have used your Vbox with any other receiver reset it before commencing with this guide.
2. On your remote Menu-Installation-Motor Setup. Enter 0000 at the prompt.
3. Motor Type = Motor
4. Satellite Tab start at 42E so we can progress across the arc numerically 39E then 36E etc.
5. To search for the satellite use the Drive step option as this uses small movements, inching it till you gain signal lock. Try other transponders to check the lock is on the correct orbital position.
6. To Store the position scroll to the command tab and press OK. This will store the orbital slot to the first available position number on the vbox, hence why I suggested you reset the Vbox at the start of this Guide.
7. Now repeat the above across the arc until you have stored all the orbital positions you require.
That’s it your done.
by ferret (thank you)