help with solo2

[ted321]

HI to all
i am new to this box and i cannot cet it to work.I have install image BH 2o6 network/longitude&latitude
press red button and the dish goto 1.west .Install channels with catseye enigma2 file 75east-45west
the dish will not move to another satellite .Keeps coming up with this BH message service unavalable
cneck tuner configuration

[echelon]

which input have you selected for the motor feed ?

and which selection have you chosen when setting up the Tuner A or Tuner B in the system menu ?

[ted321]

HI tuner A advanced is connected to the motorised dish Tuner B is setup simple&single for a fixed dish pointing at 28E

[andy gg]

Have you put your coordinates in? IE Newcastle is 55N and 1.20W
have you set USALS to yes at the the bottom of your sat page your trying to get?

[hda5]

Setup Motor (https://www.goldwafers.co.uk/Motors-and-Positioners/)ised Dish using USALS
First get your longitude & latitude info from _http://www.satsig.net/maps/lat-long-finder.htm

Enter your post code into satsig.net and you'll get the correct LON & LAT info for your location.

Example if I enter the following UK postal code: SE1 6JZ into _http://www.satsig.net/maps/lat-long-finder.htm

I get the following LON & LAT:
Longitude: -0.1042°
WEST
Latitude: 51.4979°
NORTH

Press Menu
Select Setup Press OK
Attachment 53048 (https://www.satpimps.co.uk/attachment.php?attachmentid=53048 )
Select Service searching Press OK
Attachment 53049 (https://www.satpimps.co.uk/attachment.php?attachmentid=53049 )
Select Tuner configuration Press OK
Attachment 53050 (https://www.satpimps.co.uk/attachment.php?attachmentid=53050 )
Select Tuner A Press OK
Attachment 53051 (https://www.satpimps.co.uk/attachment.php?attachmentid=53051 )

Configure Tuner for Motor (https://www.goldwafers.co.uk/Motors-and-Positioners/)ised Dish using USALS.
Attachment 53052 (https://www.satpimps.co.uk/attachment.php?attachmentid=53052 )
Use the < > buttons on remote to select Simple.
Use the down button to select mode and use the < > buttons to set to Positioner.
Attachment 53053 (https://www.satpimps.co.uk/attachment.php?attachmentid=53053 )

Configuration Mode: Simple
Mode: Positioner
Longitude: 0.104 (Make sure you enter your own Longitude settings here)
WEST
Latitude: 51.497 (Make sure you enter your own Latitude settings here)
NORTH

Press OK to save.

Press Menu
Select Setup Press OK
Select service searching Press OK
Select Positioner Setup Press OK
Select goto 0 Press RED Button

Dish should now goto 1w.

[ted321]

HI thanks for info actualy got it sorted