SWSat
26-05-2014, 11:06 AM
I have an Icecrypt STC6000HD connected to a Vbox via DISEQC 1.2 and a 1.2m Raven Dish. I have a sweep of 30W to 53E inclusive and was running firmware version HS v2.11.70. I have now upgraded to HS v2.11.87 and the problems still exist.
I have found that when I programme multiple satellites into the receiver via a Blind Scan, after adding about 16 satellites, say from 53E to 0.8W, the channel lists start to corrupt. When I do a Blind scan of the next satellite and select a channel after the scan I can receive it. If I then select a satellite that has previously been scanned, on bringing up the Channel list (Down arrow, or Ok) all the previously added channel names for that satellite are changed to the channel name I was last on. The Satellite Transponder settings are not affected, but all channels have the same name. If I cycle through all the channels, the listing updates itself back to the correct names. This continues to occur if I select any other programmed satellite, where all the channels are renamed to the previously viewed channel.
I have also found a problem where if I have an existing satellite with channels listed, if I do a new Auto, Blind or Manual Scan without clearing all TP's (Yellow button), it will only find the radio channels. Clearing all the existing TP's it finds TV and Radio Channels.
Has anyone else found these problems, is there a fix or otherwise ?
Thanks ...
I have found that when I programme multiple satellites into the receiver via a Blind Scan, after adding about 16 satellites, say from 53E to 0.8W, the channel lists start to corrupt. When I do a Blind scan of the next satellite and select a channel after the scan I can receive it. If I then select a satellite that has previously been scanned, on bringing up the Channel list (Down arrow, or Ok) all the previously added channel names for that satellite are changed to the channel name I was last on. The Satellite Transponder settings are not affected, but all channels have the same name. If I cycle through all the channels, the listing updates itself back to the correct names. This continues to occur if I select any other programmed satellite, where all the channels are renamed to the previously viewed channel.
I have also found a problem where if I have an existing satellite with channels listed, if I do a new Auto, Blind or Manual Scan without clearing all TP's (Yellow button), it will only find the radio channels. Clearing all the existing TP's it finds TV and Radio Channels.
Has anyone else found these problems, is there a fix or otherwise ?
Thanks ...