red alert
13-06-2014, 02:13 PM
Hi all,
Been ages since i last posted.
i have a Amiko motor and receiver and Triax 1.1 m dish in Birmingham UK.
Set up the motorised unit using USALS on Thor 0.8 W. The problem is the vertical pole is not 100% plum so its off prob by half centimeter. I was initially able to pick up 0.8 w and good signal quality too. After a few tweaks on the motor and dish elevation i was able to pick up good signal quality for satellites from 42 east to 1 west.
However now i cant pick up anything past 9 east. I see that 7 east is 0% quality on all frequencies. This doesnt make sence that i can pick up 9 east but not 7 East.
I check that with USALS enabled and when the motor moves to position the E/W numbers under the motor does match actual E/W number.
So i decided to re-allign the dish and motor on 0.8 W and start again and cant pick up any signal on 0.8w. This is strange considering its a easy sat to pick up. What should i do? reset the receiver back to factory setting? delete the satellite and re-install them?
i have set the motor latitude to 52 degrees.
Thanks for any help
Been ages since i last posted.
i have a Amiko motor and receiver and Triax 1.1 m dish in Birmingham UK.
Set up the motorised unit using USALS on Thor 0.8 W. The problem is the vertical pole is not 100% plum so its off prob by half centimeter. I was initially able to pick up 0.8 w and good signal quality too. After a few tweaks on the motor and dish elevation i was able to pick up good signal quality for satellites from 42 east to 1 west.
However now i cant pick up anything past 9 east. I see that 7 east is 0% quality on all frequencies. This doesnt make sence that i can pick up 9 east but not 7 East.
I check that with USALS enabled and when the motor moves to position the E/W numbers under the motor does match actual E/W number.
So i decided to re-allign the dish and motor on 0.8 W and start again and cant pick up any signal on 0.8w. This is strange considering its a easy sat to pick up. What should i do? reset the receiver back to factory setting? delete the satellite and re-install them?
i have set the motor latitude to 52 degrees.
Thanks for any help