dish wont travel

[skem4]

Hi guys , i have a slight problem with my motor it will only travel as far as 28.2 east and 19.2 east can anyone offer me some help regards skem4

[Mickha]

Have you accidentally set some software limits?
Are you using Usals, or Diseqc 1.2, to move the dish?
Can you please provide more information, regarding the receiver, and motor.
Have you checked the dish, to see if something is physically stopping it, a loose cable, or anything else?

[cannydo]

I had the same problem a while back I even bought a new motor hehe. Turned out to be grandkids set limiter so as said by Mickha check the limits m8.

PS you can use the button on the motor to make sure it's not yout motor