Wire out of DiSeqC Positioner

[peglegpete]

Hi 8 I have a1.2 Dish .It needs a DiSeqC Positioner to make it Move.the 4 wire which come from the motor at the back have come out.The wire are Red White Black Green.AT the back of the Positioner 4 port are mark M1 M2 the other 2 are Sensor.Which wire go in to which Ports
Can you Help.

[Mickha]

No one can tell you as the wires can be connected to anything.
Don't mess about with them, as you could cause damage,
You need to go to your dish, open the motor, and make a note of which colour wire connects to which port.
The M1 and M2, aren't a problem, as on the motor it might be M+ and M-, but once connected you'll know if the dish is moving the wrong way and you just move the dish back, to the starting position, then swithc the M1 and M2 wires round.
Once you have it set up please make a note, of which wires go where, I have a label, stuck on the positioner, with the relevant information.