oscam

[cannydo]

Hi there
I wondered if someone can enlighten me as how to put this https://www.satpimps.co.uk/showthread.php?168456-Oscam-y-mod-18-T34-DVBAPI-for-BH-Image onto my SE I have BH on my box. I have ftp some ipk packages before but never tgz is it the same procedure? I have done a bit of reading as I understand it this is the best cam for running keys.

[sonic1]

FTP to tmp in the same way you would any other file and the install via the addons panel.
Activate via the blue button when done.

[cannydo]

Cheers for that I did notice when I unzipped it with windows it wants to open it in a temp folder. So I presume you mean ftp the tar file inside the first zip??

Your help is much appreciated sonic1

[Mickha]

have you uploaded the CCcam files, for Black Hole, as it's the same method of installation?

As mentioned in Lee's guides, for the VU+ Duo 2:

4. Install Cam (https://www.goldwafers.co.uk/CAMS/)
Download CAM (https://www.goldwafers.co.uk/CAMS/) TGZ file from https://www.satpimps.co.uk/showthread...le-Image-EMU-S (https://www.satpimps.co.uk/showthread.php?142280-VuPlus-Community-Black-Hole-Image-EMU-S)

or the newer 2013 versions from

https://www.satpimps.co.uk/showthread...e2-emus-(2013) (https://www.satpimps.co.uk/showthread.php?161009-Vu-Plus-community-BH-oe2-emus-(2013))

FTP the cam (https://www.goldwafers.co.uk/CAMS/)-filename.tgz or ipk file to the /tmp folder on Vu+ (https://www.goldwafers.co.uk/Vu-Vuplus/) (usually this is var/tmp)
Press Green Button then Yellow Button on Vu+ (https://www.goldwafers.co.uk/Vu-Vuplus/) remote control.
Select Manual Install Bh Package.
Select the cam (https://www.goldwafers.co.uk/CAMS/)-filename.tgz file and press OK.
Message will appear - Do you want to install cam (https://www.goldwafers.co.uk/CAMS/)-filename.tgz
Select "Yes" and press OK.
Message will appear - Installed.
Press the exit button on remote a couple of times to come out of all the menus.

6. Activate Cam (https://www.goldwafers.co.uk/CAMS/)
Press the Blue button and use the < > buttons on remote to select the CAM (https://www.goldwafers.co.uk/CAMS/)
Press OK to run the CAM (https://www.goldwafers.co.uk/CAMS/).

the cccam (https://www.goldwafers.co.uk/CAMS/) cfg file is located in var/etc after the correct cam (https://www.goldwafers.co.uk/CAMS/) emu has been installed
( On E2 Boxes the 3C.config is Located at /etc with Attributes set to 755 or All config files can be found in /etc )

These instructions are for Blackhole Image other images button configurations might be slightly different.

[cannydo]

My apoliges I should of reported back i had the cam on and running 15 mins after last post.

Thanks just the same handy for reference as the grey matter aint what it used to be.