Mgcamd info?

[Satcat]

Is ther anyway of seeing my lines status when using mgcamd. I know that if using cccam, I can go to "cccam info" to see it, but there doesn't seem to be a mgcamd info option. (i'm on vix image)

[Satcat]

................................. ..........:banghead:...???

[digicon]

Hi Satcat,

I dont use the Vix image but the last time i set a receiver up for someone with the Vix image it did show the Line details and ECM times on the main info screen at the bottom of the page, have you had a look at your mg_cfg setting file to see if there is anything a miss inside which might need changing.

The obvious one:


# ECM messages
# 00 don't show anything about ecm
# 01 normal mode, show pids processed, decoded ecm and cw
# 02 verbose mode, show valid and bad ECMs with data
C: { 01 }

[Satcat]

Yea. I know I can see which line is running on the infobar, but was wondering if there was anyway of seeing a list of my lines with details, ie no. of cards. without having to stop mgcamd, starting cccam, and then looking in "cccam info".

[digicon]

Yea. I know I can see which line is running on the infobar, but was wondering if there was anyway of seeing a list of my lines with details, ie no. of cards. without having to stop mgcamd, starting cccam, and then looking in "cccam info".

Afraid not as you say you would have to use CCcaminfo or scrap Mgcamd and use Oscam as client this way you can run any sort of line you want and see Card,ECM,Hop etc.. details

[echelon]

oscam is definitely the best tool to use for these tasks, bar none ;)