AutoBouquetsMaker

[j4gz]

i try to scan on my AutoBouquetsMaker and all i get is a message saying Timeout for tuner lock how do i resolve this issue please .thanks

[bulmers]

That means its not getting a signal from the dish. Are both of your tuners configured?
Have you the dish connected to both inputs on the back of the receiver? Autobouquetsmaker by default uses lnb input 2 for its scans.

[j4gz]

Thanks for your reply i have 2 wires coming out of the lnb however i am only using one which goes to the receiver reason being i only have the one wire doing to the room where my tv is situated as the satellite tv was in the other room and the main room is Virmin one wire ...

[bulmers]

You have 2 options.

Option 1 (best option) :
Bring another cable from the LNB to your receiver. This will solve your problem and also allow you to record 1 channel while watching another channel.

Option 2 (easy option):
Disable Tuner B.
Menu > Setup > Service Searching > Tuner Configuration > Tuner B > Configuration mode "Not configured"

Reboot your receiver.

AutoBouquetsMaker should now use Tuner A (the one you are using at the moment) to scan.

[j4gz]

Cheers thanks for you help bulmers i also got 4 tuners i think it says tuner A with 2 LNB in and tuner B with 2 LNB in so 4 LNB in cable connectors so if i did get another wire coming in which slot do i use ?

[j4gz]

Tuner A :Single
Tuner B: Single
Tuner C: Single
Tuner D: Loop through to tuner C

that is how it appears on my tuner configuration.

[^^COMPASS^^]

Try changing Tuner D to not configured

IF tuner C is busy!
Then tuner D will only have available channels on the quadrant C is using

I have 3 Tuners in my DUO2 and AutoBoquetsMaker always uses Tuner C,
In your case it would be using Tuner D so try changing it to not configured.