Changing Channels

[eborg]

I have a humax 5400z. I gave delete all files file, original firmware, toh 7.9, channel list, pmc table and key bin. However the FTA channels open but the coded channels (eg D+) did not. I chose a D+ channel and I go into the toh , palser , ram editor and found that it is not on Nagra, ID 4101 but on eg Viaccess ID 1101. With the remote i push the yellow button and change to Nagra and i put the id 4101 and change the keys. But when i exit, it still does not opened. When i went back in the ram editor I found that it again changed to Viaccess ID 1101. The antenna settings are ok and the card+emu. Can someone explain how to fix this. Thanks.

[zad]

this is a common issue nowadays, its normaly solved buy clearing the ram using emu ed and then loading your keys again

[eborg]

Can you explain were I can get this emu ed and explain how to clear the ram please. Thank you.

[zad]

emu ed (dsr 9500 emued5.6cw) can be found in the tools section
clearing ram is simple, there is a tick box on the program, then click write

[McDude]

Alternatively you can load new channel settings to clear the keys/ram

[eborg]

Can you show me where to find a new channel settings file for Humax 5400z?

[voith driver]

well you could try looking at the top of the humax page, you have a choice of two threads,

https://www.satpimps.co.uk/forumdisplay.php?f=311

or even

https://www.satpimps.co.uk/showthread.php?t=58397

[eborg]

Thank you for your help - Zad, Mcdude and Voith driver

[voith driver]

hi eborg,
no problem m8, hope they help you out
all the best
voith