dcc and ftp problem

[ginjaninja]

when i open up dcc i get telnet and ftp conected but when i follow peoples tuts and see you go to ftp and select var, the problem for me is that the left hand pane is blank. any ideas.

thanks
the ninja

[peggle]

You should get -

Telnet Connected
FTP Connected

Bootmanager: not found.


If you don't get bootmanager not found you are not connected.

Check your settings, did you set up the IP address correctly & enter the right password?

[frankie1957]

make sure the password is blank if you are using a ur image ie blank as a word

[ginjaninja]

got everything as peggle has stated.

thanks
the ninja

[Gone_Fishing]

Give the image your using a password !

DCC won't work with any image if the the password is still blank !


TNT

[ginjaninja]

sorry to be thick but where do you change the password for the image.

thanks
the ninja

[Gone_Fishing]

Use Technomate Control Center, select "Update" then "PW Change" enter your ip and current password,
if there is no current password make sure thats completely empty no ************

Enter a password of your choice and click change

Job Done

Then add that password in dcc

( A good tip is to type your new password in notepad and paste it in Technomate Control Center and DCC to avoid mistakes )


TNT

[ginjaninja]

sorry was not in touch with results, but the info for the password was spot on done as you said and everything was ok, until i got back from work to find box stuck on UR splash screen and four dashes on the front of the box, could not get into boot menu to do a factory reset or anything. i managed to get it sorted with a little help, but i had to do a serial reboot and made sure the uboot img file was for the 9101 if your box is a super.

hope this can help others, also similar if stuck in a reboot loop but with this you load up uboot img for your box 9100 or 9101 if a super, then i used ds v3.5 and went from there and everything back to normal.

The NiNja