EDG-Nemesis 4.1 for original tm9100 [Archive]

echelon

10-04-2010, 01:40 PM

EDG-Nemesis 4.1 for Memory Card ( either mmc card or sdcard )

--------------------------------------------------------------------------

Unpack the files from the unpacked folder into your fat (fat16) formatted memory card.

Procedure:

Switch OFF the TM9100 receiver, and insert the SD card.

Switch ON the TM9100 receiver and the Files will load.

When complete the Receiver will report "Done" on its display.

Switch OFF the TM9100 receiver, and remove the SD card.

Carry out a Factory Reset as follows:

Switch ON the Mains power to the TM9100 whilst pressing the UP button on the Front Panel.
Using the UP or DOWN button, select on the TV screen "Factory Reset".
Start the Factory Reset by pressing the RIGHT button.
When the Factory Reset is complete, proceed with the basic setup as normal.

If you have a spare SD card it is advisable install a Swap-file on it.

USE THE CORRECT FILE FOR YOUR BOX

9100 is for the basic 9100 model only

9101 or 9100S is for the 9101 super model only