Problem

[applematt]

Having a big problem ... set everything up ... then when say I switch between 19 + 28 it loses position (using Diseqc 1.2) .. then the motor freezes -- is wont move. Turn off and leave for a few hours then I can move again and then goes again. Could be a lose wire.

Have a 1M motorised dish single LNB - Im looking at a VBOX anyone using one of these?

[canthackit]

am i right in assuming correct and you dealt with this a post up or there abouts?:woohoo-022:

regards: canthackit

[applematt]

no -- its odd -- Ive moved back to old vantage 7100 and can now pick up 19 e + 28E -- but seems to lose everyything after a few hours!

Need to gt on roof -- reckon have a lose cable. Just ordering a vbox now as well.

[applematt]

my mate got on roof -- the main cable was very loose - replaced connector and cleaned everything up now everything fine!

On the Motor the connectors should be insulated with tape ? They werent and covered now.