kenny
03-09-2008, 10:12 AM
I have just bought a TM6900 HD combo. My dish setup is slightly non-standard in that I have 3 fixed dishes and a 120 motorised going through a 4-way Disecq switch. The motorised dish has a good old actuator, and although I have a brand-new vbox sitting in its packaging, I prefer to use my 20 year-old Uniden positioner, independent of the receiver.
So my question is this - the motorised dish is on disecq position 1 - and if I scan say 1W, the channels are all saved and associated to this position. However, if I then move the dish to say 7W and tell the receiver to associate this position to disecq position 1, it *does* scan the chanels form 7W, but just saves them in the "all satellites" category. I appreciate that my fixed and motorised mixture is not "normal" but has anyone got a similar config and found a way round the problem. It's not the end of the world of course - the main thing is that channels from different satellites can be associated to disecq 1, but it would be handy to have them separated by sat position.
So my question is this - the motorised dish is on disecq position 1 - and if I scan say 1W, the channels are all saved and associated to this position. However, if I then move the dish to say 7W and tell the receiver to associate this position to disecq position 1, it *does* scan the chanels form 7W, but just saves them in the "all satellites" category. I appreciate that my fixed and motorised mixture is not "normal" but has anyone got a similar config and found a way round the problem. It's not the end of the world of course - the main thing is that channels from different satellites can be associated to disecq 1, but it would be handy to have them separated by sat position.