oldjiver
08-09-2008, 10:21 AM
My technomate 5500CIP decided to empty itself of all information this morning. (it has done that once before) So I had to re-enter all the satellite positions and frequencies. Poblem is that 30w is about 1 inch from my bungalow roof, so I have to be carefull not to knock the dish against the woodwork. This morning I was not carefull enough!!
The dish is touching the plastic cladding and I am getting "Actuator error" and it wont move either way. I have tried setting E/W limits but I get the same message.
I presume the motor is under pressure so that is why I get the error signal.
I am disabled and would find it difficult to get to the dish. Short of taking my cladding off is there anything I can do to get the motor moving away from the obstruction.?:respect-058:
The dish is touching the plastic cladding and I am getting "Actuator error" and it wont move either way. I have tried setting E/W limits but I get the same message.
I presume the motor is under pressure so that is why I get the error signal.
I am disabled and would find it difficult to get to the dish. Short of taking my cladding off is there anything I can do to get the motor moving away from the obstruction.?:respect-058: