Am I stuck with Gemini?

[Montyboy]

Hello everyone
I have had my DM800 for some time now and have tried many of the images that are available but I always have to go back to Gemini 360 or 370 as these are the only images that work with my setup.
I have an ASAT_10-1 DiseqC relais and it works perfect with Gemini, when I use the very same procedure in LNB setup with other images it just does not work, it will only find LNB1,at first I thought it was because I was using Barry Allen so I have tried from the flash but no joy.
How can it work in only one img and not in others even though the setup is the same in all images??..........Montyboy

PS.....In the LNB setup I use DiseqC 1.1.
LNB 1
Switch 1
LNB 2
Switch 2..........etc

[cdr]

@ Montyboy
have a read this may help you
good luck
................................. .......................

Setting up more than 4 LNBs for Dreambox

You will need a Universal antenna relay
(e.g. SPAUN SUR-211F for upto 8 LNBs)

This can be used with a 4 output DiSEqC switch to add 2 x 4 LNBs on 1 wire

or

(e.g. Spaun SUR 420 F for upto 16 LNBs)

This can be used with a 4 output DiSEqC switch to add 4 x 4 LNBs on 1 wire

1- Go to Setup menu by pushing the Dream button.

2- Select service searching.

3- Select Satellite configuration.

4- Select Non-standard User defined configuration.

5- Change the Satellites according to your choice,
(OK in the drop menu on each satellite name).

6- Move curser (< >) to select LNB (from 0 to 16)

7- Select LNB 0

8- Press OK to go to LNB configuration.

9- On LNB configuration setup the LNB LO/L to 9750 LO/F to 10600
(or any other values depending on LNB)

9a- For C Band LO use 5150 on both LO (this may vary for C band LNBF).

10- Push BLUE button to go to next menu.

11- Select the DiSEqC Parameter according to your LNB sequence as follows
:

A/A=3D DiSEqC 1
A/B=3D DiSEqC 2
B/A=3D DiSEqC 3
B/B=3D DiSEqC 4

12- Select Uncommitted Switch.

13- Set Input 1 for the 1st DiSEqC.

14- Repeat the above steps for the 2nd DiSEqC.
Set Input 2 for the 2nd DiSEqC (and so on)

15- Push the GREEN button to save your setting.

16- You now have 8 LNBs configured.