"No access" message on screen

[kenny]

I have a Diablo with UW 135 which clears the Conax channels fine on 1W, but the problem is that I on my TM6900, I have a "No access" info message stuck in the middle of the screen, and I can't seem to get rid of it! I don't think the message is coming from the Diablo, since I have "Show never" set for the CAM. Any ideas?

[kenny]

Well, I just discovered a bizarre way to get rid of the "No access" message....If I press record on the TM6900 (I have a HDD on the USB port) - the message disappears. Not very satisfactory, because then to change channels I have to stop recording - but I suppose it will do until someone out there tells me the errors of my ways....

[kenny]

Thanks for the reply - but the patch is already off - so it must be something else.....btw s/w version is 6.56, which I think is the latest

[echelon]

Thanks for the reply - but the patch is already off - so it must be something else.....btw s/w version is 6.56, which I think is the latest


no its not , 6.58p is the latest !!

[^^COMPASS^^]

usually you would get this message if you have a conax smart card inserted into the receivers card reader.

[kenny]

Top man, compass! I never thought of that... I had a D*gitalb card in the card reader ..... took it out and hey presto.....thanks very much.

[echelon]

looks like you need to be more observant ...!!! lol :)

card in slot

new uw136 is out

new 6.58p patch is out

update the lot , remove that card , now test it :)