6800HD Problem with upset motor

[korset777]

Hello,

I have just installed a 6800HD (not super) but having problems with the motor installation. I have a 36 Volt motor and a VII box. I have connected the cables as said in the manual.
What is the right motor installation? Shall I use 1,2 Diseque or USALS?
I can get the motor to move, but just manually when I press the blue button. But when I choose a satellite it says it is moving but the antenna is not moving.

What have I done wrong? Can someone give me a small guiding for the right upset for motor installation.

Thank you very much!!

Regards,

[madsod]

1.2 for 36 volt save each one i found best with the t/mate handset . so you will need to find each sat and save then it will then go back to each one

[jamesjay]

Have you set your east to west limits...how to do this is on pages 17 to 18 of my TM 6900 super manual...it could be a different page on your manual.

Also I use 1.2 and find it very accurate.

[korset777]

Thanks a lot for your help.

I have now sorted it out. I use 1.2 diseque, but I did a factory reset on the receiver first and also on the VII-box (counting down from 10 to 0).
Now it is working OK. I have not set the east-west limits, but I have saved each satellite used and they are not so close to the limits.
Thanks.