Clone visionnet from another receiver ?

[stu1st]

Hello guys,

How can i clone my visionnet receiver from another receiver (visionnet too ofcourse) via Rs232 cross cable ?? i have seen once a guy doing it in a repair shop but i dont remember the procedure, i mean the cable was connected to both of them but my question is, how to know who is copying to who ???

Any clue guys ?

[dxdy]

if you want clone VN with payserver this not possible.....

[stu1st]

ok lets say its not a pay server, technically how can it be done ??

[dxdy]

i not worked with official software 2 years... i forgot....

[stu1st]

Thanks bro, anyone else out there has a clue ?

[snakie]

1 box must be turned on , the other off , connected with cross serial cable.Then you switch on the second box and it starts to download the firmware from the other.But this depends on the firmwares that are on each box.
If you wanna full clone the box, then you have to read the flash contents with jtag connection and flash the other box with jtag again.
Its been around 2 years to mess with their firmwares ( did some patches for 2.0x versions with free servers ) so excuse me if i forgot something to mention.